Pollen Twist FAQ
Rosin in its broadest definition is a solventless extract made with only the use of heat and pressure. Rosin can be obtained by pressing essentially any material between two heated platens. During the rosin process, heat allows for the plants essential oils containing the terpenes we all love to become more viscous and pushed onto a paper where it can be collected.
The purpose of a rosin filter bag is to keep contamination out during the rosin process. There are various micron sizes specific for the type of material you’re processing. See the guide table by pressing here.
Yield is a ratio between the input material and the output material, and can vary depending on the quality of the material being pressed. Generally the yield of a rosin press machine is around 20%. This means for every 5g of material you put into the machine, you will end up with 1g of rosin.
- Flower yields can range from 15%-30%+ for quality flower.
- Concentrate yields can range from 30%-80%
Pre-pressing is the process of pressing and densely compacting your material in a dry mould. This process isn’t necessary however it increases the yield of your press, hence reducing wastage. We highly recommend pre-pressing before heat pressing.
The optimal temperature depends on the material you’re attempting to press.
- Dry Sift – Prime Temperature: 74C to 90C
- Flower – Prime Temperature: 87C to 105C
This is also depending on the material you’re pressing and we would advise to test various times to see the results. However, you can follow the information in the bullet points below for a rough guide.
- Dry Sift – Heating Time: 60s to 130s
- Flower – Heating Time: 30 to 220s
The micron bag is dependant on the material being pressed. Generally the larger the size of the material in its natural form, then the larger micron you will need to generate a good quality rosin without sacrificing the yield produced.
- 25U* – Fine materials such as dry sift
- 100U* – Flower; results in best filtration and highest quality output with some reduction in yield
- 160U* – Flower; good balance between yield and quality
*U = Micron Size
This depends on how much pressure you can apply and the surface area of the platens. We recommend to have 1-ton available for every 2.5 sq/cm of material surface area. This insures you always have enough pressure to extract your oil without the need for a repress.
We recommend pressing between 0.25g to 7g (per press).
A small 0.25g flower can be pressed out easily and quickly.
Yes the Pollen Press comes with 12-months warranty.
STAY TUNED WITH NECTAR’S NEWS & PROMOTIONS